[. . . ] Tapes recorded with the REC TIME/ PLAY MODE switch in the DOUBLE position cannot be played properly on a tape recorder without the REC TIME/PLAY MODE switch function. ⷠConnect the AC power adaptor to an easily accessible AC outlet. [. . . ] If the sound is too soft, on the contrary, the unit will not start recording. Set it to H (high) or L (low) so that the system will pick up the necessary sound only. ⷠThe VOR system may not record the beginning of the sound you want to record because it starts recording only after it catches the sound. We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Use the unit away from radiowave-emitting devices such as cellular phones. (TCM-200DV only) · SPEED CONTROL is set at a point other than the center (TCM200DV only). In the direction of the arrow To release pause playback, release PAUSE . Search forward Press and hold during M FF/CUE and playback (CUE) release it at the point you want. Search backward during playback (REVIEW) Fast forward** Rewind** Press and hold m REW/REVIEW and release it at the point you want. M FF/CUE during stop m REW/REVIEW during stop z REC Use a microphone of low impedance (less than 3 k) such as the ECM-115 (not supplied). When using a plug-in-power system microphone, the power to the microphone is supplied from this unit. note When recording with an external microphone, the VOR system may not work properly due to difference in sensitivity . To clean the tape heads and path press z REC while pushing the lever in the tape compartment. [. . . ] Away from the unit to prevent possible damage from the magnet used in the speaker. ⷠIf the unit has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a tape. [. . . ]